6.2.13.5. Stream speed measuring instrument
The measuring instrument is mounted on the right side of the gate case.
Removal and installation
- 1. Maintenance instruction
- 2. Maintenance
- 3. Engines
- 4. Cooling system
- 5. System of heating and ventilation
- 6. Fuel and exhaust system
- 6.1. Carburetor engines
- 6.2. Engines with system of injection of fuel
- 6.2.1. Specifications
- 6.2.2. Air filter
- 6.2.3. Cable of the drive of a butterfly valve
- 6.2.4. Pedal of management of a butterfly valve
- 6.2.5. Fuel
- 6.2.6. System of injection of fuel
- 6.2.7. Decompression of fuel system
- 6.2.8. Fuel pump
- 6.2.9. Fuel level sensor
- 6.2.10. Fuel tank
- 6.2.11. System of injection of fuel
- 6.2.12. Case of a butterfly valve
- 6.2.13. Units of system of injection of fuel
- 6.2.13.1. Distributor of fuel and nozzle
- 6.2.13.2. Pressure regulator
- 6.2.13.3. Sensor of a butterfly valve
- 6.2.13.4. Perepuskna air valve
- 6.2.13.5. Stream speed measuring instrument
- 6.2.13.6. The valve of correction of idling at change of load of the engine
- 6.2.13.7. The thermostat of the raised idling turns
- 6.2.13.8. Sensor of an angle of rotation of the crankshaft and transistor module
- 6.2.13.9. Sensor of temperature of cooling liquid
- 6.2.13.10. Processor block
- 6.2.13.11. Switch of neutral position of the check point
- 6.2.13.12. Switch of a starter and signal of the movement by a backing
- 6.2.13.13. Relay of the fuel pump and control unit
- 6.2.13.14. The switch of correction of idling during the operation of the hydraulic booster
- 6.2.13.15. The switch of correction of idling during the operation of the conditioner
- 6.2.13.16. Car speed sensor
- 6.2.14. The soaking-up collector
- 6.2.15. Final collector
- 6.2.16. Exhaust system
- 6.3. System of food / production of the fulfilled gases
- 6.4. System of decrease in toxicity of the fulfilled gases
- 7. System of launch of the engine
- 8. Coupling
- 9. Transmissions
- 10. Half shafts
- 11. Brakes
- 12. Suspension brackets and steering
- 13. Body
- 14. Electric equipment
